Therefore,a multi-tap delay is a single delay with multiple outputs (taps) along the delay. When you play several such delayed signals along with the original where each signal is delayed by a different amount, you have a multi-tap delay. When you add this delayed copy to the original, some extraordinary effects can be created. What is a delay line?Ī delay line simply plays a copy of the original signal following a delay of a certain amount of time.
#Waves h delay vs supertap software
The SuperTap doesn’t try to directly emulate all of them, but you have a huge set of tools to work with to do exactly that, or create completely new effects only available in digital software tools. There have been many versions, including analog “bucket brigade” types, digital, acoustic, tape, and more, each with their own flavor and character. You can control the depth (in milliseconds) and the rate of variation.Īudio delays have widespread use in studios and sound design and have been used for quite some time, dating from the earliest recording devices. Modulating the taps produces variation in the delay times, which changes the pitch from each tap. In order to give you great flexibility, there is also the small danger of very loud feedback sounds, so it is best to use low feedback values and adjust it slowly.Ħ. The feedback section in the lower left corner is worthy of a warning! Using feedback can produce increasingly louder sounds, well into distortion, just as the analog equivalents can do. You can filter each tap separately for a very large range of creative rhythm effects from a single sound source.ĥ. On the right side is the EQ/Filter section, with on/off control, 5 filter types,plus gain control for the bell and shelving filters. (Panning is only for mono signals, Rotation works with mono and stereo, so that is why it is here).Ĥ.
Drag a Pan Graph marker to change Gain and stereo position (rotation) at the same time, or adjust the Gain and Rotation controls separately for each tap. Drag the tap marker to set the delay time for each tap.ģ. Notice that when you turn a tap on, it illuminates in all three buttons: the on button itself, the delay slider, and the Pan Graph (for stereo plugins).Ģ. The on/off button is on the left, going across to the EQ section. Each tap’s controls are arranged in a row from left to right. The factory presets (located in the Load menu) are a great place to start, but take a little time to read at least this page! There’s lots to know about this processor that will save you time.ġ. The default setting of any of the components has all the taps turned on, without Feedback. Launch one of the SuperTap components from your plug-in menu. Maximum delay time may vary from application to application Note: The components without modulation are not available in native applications. The Modulation versions have shorter delay times (1.2 seconds) the components without modulation have the longest delay times (6 seconds).
In your menu, you’ll see four different component plugs, or “sub-plugins” of SuperTap: 6-taps (with and without Modulation) and 2-taps (with and without Modulation).
#Waves h delay vs supertap full version
Please note that the TDM and Native Power Pack products come with a 2-tap-only version of SuperTap the full version is part of either the Pro-FX Plus or Gold products. You can also choose between 2 or 6 taps for either type,as well as mono or stereo.
At the most basic,there are two types of SuperTap processing: one with modulation, or one with longer taps.